Scroll Saw Chuck Heads by Pegas - For Excalibur Type Saws - Also Works with DeWalt - see list

Upgrade your Scroll Saw with Pegas Blade Chuck Heads - 40% lighter, Less Vibration.

Set of Upper and Lower Scroll Saw Blade Clamp Replacements.  These new “Blade Chuck Heads” (also known as Blade Clamps) were developed in Switzerland by Pégas in association with the HEIG engineering school in Yverdon. The studies and the tests demonstrated that the weight of these heads is in direct relation with the service life and the vibrations of the machine.

1) These new heads, manufactured with aeronautical aluminum for resilience and optimal weight, are 40 % lighter than you original Heads. 

2) Vibration will be greatly reduced

3) Changing Blades is easier and faster

4) Better protection of the mechanical parts of the scroll saw.

Note - The Set Screws and Thumb Screws are wear parts on any blade clamps, and should be replaced every few months or couple of years depending on how much you use your scroll saw - Click here to see our selection of renewal kits.

As you can see, they are clearly more compact than original heads and even easier of use. The assembly of these new Heads is very simple and takes only a few minutes.

All parts are included to make this quick and simple replacement.  Steve Good's review above also shows how to remove your existing blade clamps and install the new one.