Scroll Saw Chuck Heads by Pegas - For Delta & DeWalt Scroll Saws

Blade Chuck Heads Made for Delta 690 & Delta 40-694 & DeWalt 788 Scroll Saws

Set of Upper and Lower Blade Clamps - These new “Blade Chuck Heads” (also known as Scroll Saw Blade Clamps) were developed in Switzerland by Pégas in association with the HEIG engineering school in Yverdon. The studies and the tests demonstrated that the weight of these heads is in direct relation with the service life and the vibrations of the machine.

See Steve Good of the Scroll Saw Workshop's full review, plus detailed assembly instructions.

This replacement parts set includes lower and upper blade clamps compatible with the Dewalt DW788-20 inch scroll saw, and the Delta 40-694-20 inch scroll saw. Works perfectly for BOTTOM and TOP feeding scrollers.

1) These new heads are slightly lighter than the original Dewalt/Delta Chuck Heads.

2) Vibration will be greatly reduced

3) Changing Blades is easier and faster

4) Better protection of the mechanical parts of the scroll saw.

5) The assembly of these new Heads is very simple and takes only a few minutes.

Note - The Set Screws and Thumb Screws are wear parts on any blade clamps, and should be replaced every few months or couple of years depending on how much you use your scroll saw - Click here to see our selection of renewal kits.

Blade Chuck Version Comparison	Components	Suitable For Which Saws	Reviews and Assembly Instructions
1) SS-PEGAS-CHUCK with Tension Lever The Original	Top and Bottom Scroll Saw Blade Clamps plus Tension Lever	Suitable for all EXCALIBUR (green, Anniversary and black models), EXCELSIOR, SEYCO ST-21 and KING Scroll Saws. Lots of people are already loving them for the DeWalt 788 and Delta 690 as well.	Review by Steve Good.
2) SS-DWPEGAS-CHUCK	Top and Bottom Clamp replacement (No tension lever as there is one at the front of these saws)	For DeWalt 788 and Delta 690	Review by Steve Good.
3) SS-JETPEGAS-CHUCK	Bottom Blade Clamp replacement. (Want to change both clamps? Order the Original.)	JET JWSS-22 Scroll Saw.	See Steve's comments in the post on the Original. Review by Steve Good.

Photos are taken from Steve Good's Blog post referenced above.

Scroll Saw Chuck Heads by Pegas - For Delta & DeWalt Scroll Saws

Your name we can display:

Your email (not displayed):

Highlight (eg "happy customer" or "great quality"):

Write your review:

Remaining characters:

Blade Chuck Heads Made for Delta 690 & Delta 40-694 & DeWalt 788 Scroll Saws

This replacement parts set includes lower and upper blade clamps compatible with the Dewalt DW788-20 inch scroll saw, and the Delta 40-694-20 inch scroll saw. Works perfectly for BOTTOM and TOP feeding scrollers.